Z-Axis Tool Setting Touch Probe

Specifications:

The dimensions for the the touch probe are as follows:
Cable Length (A): 110cm
Diameter (B): 35mm
Height (C): 20mm

Tips and Tricks:
Wire your touch probe’s cable and ensure that the screws are tightened.
Place your touch probe on top of the work piece.
Connect the EDG connector to your controller board.
Attach the Touch probe alligator clip to your end-mill.
Activate your machine and manually jog the machine to the middle of the touch probe about 5mm off of the probe’s surface.
Use the relevant software to begin the probing process and therefore zero your work piece.