16 channel Servo Motor USB UART Controller Driver

Features:

 16 channel servo control board,8 channel with over load protection
- This board can control up to 16 servo motor coordination action, has the position control and speed control, not only can use PC software to control, but also can use MCU (51, AVR, ARM, FPGA, PIC) UART communication (TTL serial) to send commands to control servo motor, and also can download to the instructions(code got from the PC software) to the servo motor controller, realize offline operation.

Specifications:

- Controlling chip power supply range: 6.5V~12V or 4.5 V~5.5 V.
- Servos power supply range: DC (voltage depends on the parameters of the servos, commonly 5V DC).
- Control channels: can control 16channels at the same time,speed is precisely adjustable.
- Communications input: USB or serial port (TTL, UART). (can use wireless bluetooth module or other wireless module to wireless control)
- Signal output: PWM (accuracy of 1us).
- Servo motor driver resolution: 1us, 0.09 degrees.
- Baud rate range: 9600 19200 38400 57600 115200 128000. (fully automatic identification, no need setting)
- Support of servo motors: Futaba, Hitec or others.
- PCB size: 55 mm x 40 mm (installation hole spacing: 34 * 39 mm).
- Control mode: USB and serial interface (TTL) accept command mode.
- Flash: on-board 512 K ROM.